Search
Advanced search
Filter by category
Filter by committee
Search results
-
No industry standard currently exists that addresses the vacuum sealing requirements of knife-edged flanges for high vacuum applications. Existing international standards focus on interchangeability of the hardware, but do not address the reliability of the seal. ASTM International Committee E42 on Surface Analysis is now working on a proposed standard on the subject, WK21206 , Specification…
-
A 2002 workshop on galling wear held by ASTM International Committee G02 on Wear and Erosion provided the impetus for the development of a new standard, ASTM G196 , Test Method for Galling Resistance of Material Couples. The new standard is under the jurisdiction of Subcommittee G02.40 on Non-Abrasive Wear. According to Scott Hummel, Ph.D., associate professor, head of the department of…
-
Analysts in laboratories that use regression-based methods to determine uncertainty in data and customers that request such measurements will be the primary users of a new standard recently approved by ASTM International Committee D19 on Water. ASTM D7366 , Practice for Estimation of Measurement Uncertainty for Data from Regression-Based Methods was developed by Subcommittee D19.02 on Quality…
-
ASTM International Committee F03 on Gaskets has developed and approved a new standard that can be used to evaluate gasket materials covered by ASTM F104 , Classification System for Nonmetallic Gasket Materials. The new standard, F2716 , Practice for Comparison of Nonmetallic Flat Gaskets in High Pressure Saturated Steam, is under the jurisdiction of Subcommittee F03.10 on Composite Gaskets. ASTM…
-
A new ASTM International standard responds to a recent emphasis by regulatory agencies that firms manufacturing drug products demonstrate the efficacy of disinfectants used in controlled environments. The standard, ASTM E2614 , Guide for Evaluation of Cleanroom Disinfectants, was developed by Subcommittee E35.15 on Antimicrobial Agents, part of ASTM International Committee E35 on Pesticides and…
-
Cyanide is routinely analyzed in water samples, often to demonstrate regulatory compliance; however, improper sample collection or pretreatment can result in significant positive or negative bias potentially resulting in unnecessary permit violations or undetected cyanide releases into the environment. Because of the importance and timeliness of these issues, ASTM Subcommittee D19.06 on Methods…
-
While nearly all of the instrumentation employed in the field to measure radioactive materials or radiation exposure rates used to be in the hands of state radiological control agencies or federal government national response organizations, this is no longer the case. Now, law enforcement personnel, first responders and other professionals have radiation detection instruments, though they may not…
-
ASTM International Committee D19 on Water will host a workshop on turbidity during the June Committee Week in Norfolk, Va. Subcommittee D19.07 on Sediment, Geomorphology and Open Channel Flow will present the workshop from 1:00 to 5:00 p.m. on June 26, 2007. According to Mike Sadar, D19 member and principal application scientist, Hach Company, Committee D19 has invested several years in the…
-
A proposed new standard currently being developed by ASTM International Committee F01 on Electronics will prove to be useful to the tantalum sputtering target industry. The proposed standard, WK9490, Test Method for Reporting Crystallographic Orientation of Sputtering Target Materials, is under the jurisdiction of Subcommittee F01.17 on Sputter Metallization. "The tantalum sputtering target…
-
ASTM International Committee F01 on Electronics is currently developing a proposed new standard that will provide uniformity in the values reported for oxygen content in aluminum alloys used for sputtering targets in the manufacture of integrated circuits. The proposed standard, WK9120, Determination of Oxygen in High Purity Aluminum and Alloys in High Purity Aluminum Base by Inert Gas Fusion…