Search
Advanced search
Filter by category
Filter by committee
Search results
-
ASTM International Committee F12 on Security Systems and Equipment invites all interested parties to participate in the current revision of ASTM F967 , Practice for Security Engineering Symbols. The standard is under the jurisdiction of Subcommittee F12.10 on Systems, Products and Services. According to Ed Conrath, senior principal, Protection Engineering Consultants, and F12 committee chairman,…
-
“Bumping” is a process that can allow virtually anyone to covertly operate a pin tumbler lock. A long-held locksmith secret, bumping has become more well known as videos describing the process of making and using a bump key have surfaced on the Internet. Potential intruders can use the bumping process to break into homes and other buildings while leaving the impression that something must have…
-
Air permits from regulatory agencies, such as the U.S. Environmental Protection Agency (USEPA), often require the measurement of a plume's opacity as the plume is emitted from a stationary point source (for example, smokestacks) in the outdoor ambient environment. While such opacity is often visually measured by human observers as “certified smoke readers,” an opacity measurement method using…
-
The measurement of acid mist is becoming increasingly important due to recent actions taken by the U.S. Environmental Protection Agency on fine particles (2.5 micrometers in diameter and smaller) that are unhealthy to breathe. ASTM International Committee D22 on Air Quality is currently working on a proposed standard for measuring acid mists that come from combustion sources, WK22846 , Test…
-
No industry standard currently exists that addresses the vacuum sealing requirements of knife-edged flanges for high vacuum applications. Existing international standards focus on interchangeability of the hardware, but do not address the reliability of the seal. ASTM International Committee E42 on Surface Analysis is now working on a proposed standard on the subject, WK21206 , Specification…
-
A 2002 workshop on galling wear held by ASTM International Committee G02 on Wear and Erosion provided the impetus for the development of a new standard, ASTM G196 , Test Method for Galling Resistance of Material Couples. The new standard is under the jurisdiction of Subcommittee G02.40 on Non-Abrasive Wear. According to Scott Hummel, Ph.D., associate professor, head of the department of…
-
A new ASTM International standard provides guidance for using data generated by ASTM standards in testing for asbestos in surface dust. ASTM D 7390 , Guide for Evaluating Asbestos in Dust on Surfaces by Comparison Between Two Environments, was approved by ASTM International Committee D22 on Air Quality, part of Subcommittee D22.07 on Sampling and Analysis of Asbestos. According to James Millette…
-
ASTM International Committee F12 on Security Systems and Equipment has approved a new standard, F 2656 , Test Method for Vehicle Crash Testing of Perimeter Barriers. The new test method, developed by Subcommittee F12.10 on Systems, Products and Services, provides a range of vehicle impact conditions, designations and penetration performance levels for the testing of perimeter barriers that are…
-
A new ASTM International standard will provide a method to consistently address indoor air quality complaints in residential buildings and to guide IAQ investigations in an efficient manner. The standard, D 7297 , Practice for Evaluating Residential Indoor Air Quality Concerns, is under the jurisdiction of Subcommittee D22.05 on Indoor Air, part of ASTM International Committee D22 on Air Quality…
-
It has become a common scene: a driver in a parking lot suddenly loses control of a car, sending it into a storefront or other pedestrian area. In an effort to minimize the injury and damage caused by such crashes, ASTM International Committee F12 on Security Systems and Equipment is developing a proposed new standard, WK13074 , Test Method for Crash Testing of Low Speed Pedestrian Barriers. The…