Search
Advanced search
Filter by category
Filter by committee
Search results
-
Modified bitumen products have been in use since the mid-1970s, and represent a substantial percentage of the commercial asphalt roofs installed throughout North America. A new ASTM International standard addresses the use of cold process adhesives in modified bitumen roofing systems. ASTM D7379 , Test Methods for Strength of Modified Bitumen Sheet Material Laps Using Cold Process Adhesive, was…
-
As a means of ensuring the safety of electrical wiring systems in airplanes, ASTM International Committee F39 on Normal and Utility Category Airplane Electrical Wiring Systems has recently approved F2639 , Practice for Design, Alteration and Certification of Airplane Electrical Wiring Systems, a standard developed by Subcommittee F39.01 on Design, Alteration and Certification. According to…
-
An ASTM International task group on battery separator materials is currently working on the latest in a series of standards being developed for alkaline battery separators. The proposed new standard, WK13587 , Test Methods for Sampling and Testing Materials That Are Used for Alkaline Battery Separators, is under the jurisdiction of Subcommittee D09.19 on Dielectric Sheet and Roll Products, which…
-
A new ASTM International standard, F 2490 , Guide for Aircraft Electrical Load and Power Source Capacity Analysis, has been accepted by the Federal Aviation Administration (FAA) as a means of compliance with 14 CFR 23.1351(a) (2), Electrical System Capacity for Part 23 (and Predecessor) Aircraft. Guide F 2490 was developed by Subcommittee F39.01 on Design, Alteration, and Certification, which is…
-
ASTM International Committee F16 on Fasteners has recently approved an important new standard that deals with coated threaded fasteners and washers by hot-dip zinc galvanizing. The standard, F 2329, Specification for Zinc Coating, Hot-Dip, Requirements for Application to Carbon and Alloy Steel Bolts, Screws, Washers, Nuts and Special Threaded Fasteners, is under the jurisdiction of Subcommittee…
-
ASTM International Committee F16 on Fasteners has developed a new standard, F 2329, Specification for Zinc Coating, Hot-Dip, Requirements for Application to Carbon and Alloy Steel Bolts, Screws, Washers, Nuts, and Special Threaded Fasteners. The standard, which is under the jurisdiction of Subcommittee F16.03 on Coatings on Fasteners, covers the requirements for hot-dip zinc coating applied to…
-
ASTM International Committee F39 on Normal and Utility Category Airplane Electrical Wiring Systems has approved its first standard, F 2490, Guide for Aircraft Electrical Load and Power Source Capacity Analysis. The new guide covers how to prepare an electrical load analysis to meet Federal Aviation Administration requirements. "This standard is a model for a consistent method of determining the…
-
Two newly approved ASTM standards are filling a gap that has existed for tests for battery separators. The new standards, D 7129, Test Method for Determination of Ammonia Trapping in a Grafted Battery Separator, and D 7131, Test Method for Determination of Ion Exchange Capacity (IEC) in a Grafted Battery Separator, are under the jurisdiction of Subcommittee D09.19 on Dielectric Sheet and Roll…
-
ASTM International Committee D09 on Electrical and Electronic Insulating Materials will host a presentation of the European Unions Restriction of Hazardous Substances (RoHS) Directive during their meeting in Philadelphia, Pa. on March 15. The meeting will run from 3:00 to 5:00 p.m. and will be followed by a social hour. Electrical equipment marketed in the EU after July 1, 2006, must comply…