Search
Advanced search
Filter by category
Filter by committee
Search results
-
A series of proposed new standards being developed by ASTM International Committee D15 on Engine Coolants would remove technical barriers that currently prevent the cost-effective replacement of ethylene glycol with more environmentally friendly glycerin in antifreeze. The proposed standards are under the jurisdiction of Subcommittee D15.93 on Research and Long Range Planning. Natural glycerin is…
-
No industry standard currently exists that addresses the vacuum sealing requirements of knife-edged flanges for high vacuum applications. Existing international standards focus on interchangeability of the hardware, but do not address the reliability of the seal. ASTM International Committee E42 on Surface Analysis is now working on a proposed standard on the subject, WK21206 , Specification…
-
A 2002 workshop on galling wear held by ASTM International Committee G02 on Wear and Erosion provided the impetus for the development of a new standard, ASTM G196 , Test Method for Galling Resistance of Material Couples. The new standard is under the jurisdiction of Subcommittee G02.40 on Non-Abrasive Wear. According to Scott Hummel, Ph.D., associate professor, head of the department of…
-
Responding to an increasing level of interest from engineers, regulators and communities, ASTM International Committee C27 on Precast Concrete Products has formed new Subcommittee C27.70 on Precast Concrete Products for Stormwater Management. “New environmental regulations, as well as vastly improved methods of meeting these, have created many new products and practices for stormwater management…
-
In response to changing emissions restrictions and consumer expectations, ASTM International Committee D15 on Engine Coolants is now developing a proposed new standard, WK16003 , Specification for Engine Coolant Grade 1,3-propanediol (PDO). This task group is under the jurisdiction of Subcommittee D15.07 on Specifications. Edward Eaton, D15 member and chief engineer, Amalgatech, says that as…
-
Although alkali resistant glass fibers have been commercially available for more than 30 years, there has not been an official standard that clearly defines what is required to make glass fibers resistant to alkali attack without the need for protective coatings. ASTM International Committee C27 on Precast Concrete Products has recently developed such a standard, C 1666/C 1666M , Specification…
-
Ineffective removal of grease from restaurants poses a variety of serious environmental problems. Large quantities of grease in public sanitary sewer systems can cause stoppages of piping networks and create costly and time-consuming problems at treatment plants. Sewer backups resulting from grease can also create health hazards when raw sewage backs up into homes or businesses. While grease…
-
A proposed new specification currently being developed by ASTM Committee C27 on Precast Concrete Products addresses the issue of watertightness in septic tanks and grease interceptors. The proposed standard, WK7426, Specification for Resilient Connectors Between Reinforced Concrete Tanks and Pipes, is under the jurisdiction of Subcommittee C27.30 on Water and Wastewater Containers. "The entries…
-
ASTM International Committee E42 on Surface Analysis has approved a new standard, E 2382, Guide to Scanner and Tip Related Artifacts in Scanning Tunneling Microscopy and Atomic Force Microscopy. The guide, under the jurisdiction of Subcommittee E42.14 on STM/AFM, was proposed in order to assist new scanning probe microscopy users with more rapid recognition and assessment of artifacts in imaging…