Search
Advanced search
Filter by category
Filter by committee
Search results
-
The ongoing focus on sustainability in construction has contributed to greater interest in vegetative, or green, roof systems, in which traditional roofing material is replaced or supplemented with vegetation. A proposed new ASTM International standard will address an important aspect of designing this kind of roofing: determining the proper roofing and waterproofing membrane for a particular…
-
No industry standard currently exists that addresses the vacuum sealing requirements of knife-edged flanges for high vacuum applications. Existing international standards focus on interchangeability of the hardware, but do not address the reliability of the seal. ASTM International Committee E42 on Surface Analysis is now working on a proposed standard on the subject, WK21206 , Specification…
-
The use of rolling devices can provide a means to evaluate the adhesion of weather seals, for quality control in new installations, general evaluation of existing installations, and the investigation of water and air leakage through building enclosures. In order to better facilitate the use of rolling devices, ASTM International Committee C24 on Building Seals and Sealants is developing a…
-
A 2002 workshop on galling wear held by ASTM International Committee G02 on Wear and Erosion provided the impetus for the development of a new standard, ASTM G196 , Test Method for Galling Resistance of Material Couples. The new standard is under the jurisdiction of Subcommittee G02.40 on Non-Abrasive Wear. According to Scott Hummel, Ph.D., associate professor, head of the department of…
-
When fasteners penetrate roofing or waterproofing products as a planned part of installation, it is expected in some cases that the product will resist water migration at the point of penetration. A new ASTM International standard, D7349 , Test Method for Determining the Capability of Roofing and Waterproofing Materials to Seal Around Fasteners, addresses this situation. ASTM D7349 was developed…
-
Modified bitumen products have been in use since the mid-1970s, and represent a substantial percentage of the commercial asphalt roofs installed throughout North America. A new ASTM International standard addresses the use of cold process adhesives in modified bitumen roofing systems. ASTM D7379 , Test Methods for Strength of Modified Bitumen Sheet Material Laps Using Cold Process Adhesive, was…
-
ASTM International Committee C16 on Thermal Insulation will hold a forum on “Thermal Insulation in 2008: Perspectives on Economic Thickness, Contributions to Sustainability, and Design of Power & Process Facilities” on Monday, April 7, 2008, from 5 to 6 p.m., in Anaheim, Calif. The forum will be held in conjunction with the April 6-9 standards development meetings of the committee. Three…
-
Work is continuing on a proposed new ASTM International standard that will aid laboratories and materials manufacturers in testing the moisture properties in construction materials. The proposed standard, WK16466 , Test Method for Moisture Retention Curves of Porous Building Materials Using Pressure Plates, is under the jurisdiction of Subcommittee C16.33 on Insulation Finishes and Moisture, part…
-
A new ASTM International standard, C 1639 , Specification for Fabrication of Cellular Glass Pipe and Tubing Insulation, covers techniques for fabricating cellular glass blocks into billets that are then used to make pipe and tubing insulation. The standard, which was developed by Subcommittee C16.40 on Insulation Systems, part of ASTM International Committee C16 on Thermal Insulation, will be…
-
Andrea Russell, sustainability manager, Rio Tinto Minerals, will speak on "The Basics of Life Cycle Assessment and Insulation" on April 16, 2007, in conjunction with the meetings of ASTM International Committee C16 on Thermal Insulation during the April Committee Week in Norfolk, Va. Russell's presentation, which will take place from 6:00 to 7:00 p.m. at the Waterside Convention Center, is part…