Search
Advanced search
Filter by category
Filter by committee
Search results
-
The U.S. Environmental Protection Agency is currently revising its New Source Performance Standard (NSPS) for Wood Heaters. Every indication is that a proposed ASTM International standard on particulate matter emissions that is being developed by Committee E06 on Performance of Buildings will be included in the revised NSPS. ASTM WK27994 , Test Method for Determining Particulate Matter Emissions…, ASTM Committee E06 Next Meeting:, Oct. 10-13, October Committee Week, San Antonio, Texas, Technical Contact:, Robert Ferguson, Ferguson, Andors and Co., South Royalton, Vt., Phone: 802-763-2339; facomail@sover.net, ASTM Staff Contact:, Stephen Mawn, Phone: 610-832-9726; smawn@astm.org, ASTM PR Contact:, Barbara Schindler, Phone: 610-832-9603; bschindl@astm.org Release #8610
-
A new ASTM International standard can now be used to better measure construction productivity at three levels: task, project and industry. The new standard, ASTM E2691, Practice for Job Productivity Measurement, was developed by Subcommittee E06.81 on Building Economics, part of ASTM International Committee E06 on Performance of Buildings. “Productivity cannot be improved to be at par with the…
-
Being able to complement marketing claims in advertising and promotions with third-party certification or verification is important in any industry. A new ASTM subcommittee will be working on standards for such verification in the livestock and meat industry. The new subcommittee, F10.60 on Livestock, Meat and Poultry Marketing Claims, is part of ASTM International Committee F10 on Livestock,…
-
There has been a renewed interest in instrumental qualification and standardization by the fluorescence community over the last 10 years, driven by the increasing number of quantitative chemical assays that use fluorescence detection and the presence of regulations in some of these areas. After revising three test methods for fluorescence instruments, stakeholders decided that a standard guide…
-
The
-
Flow characteristics of fine metal powders are important in filling dies for pressing of powder metallurgy compacts, which are later sintered and sometimes machined into finished parts. The flow rate, as measured by a new ASTM standard, determines the flow necessary for a precise quantity of powder to be introduced into the die. The new standard, B964 , Test Methods for Flow Rate of Metal Powders…
-
Inert gases that are found in insulating glass units help make windows more energy efficient. A new ASTM International standard provides a long-needed method for evaluating gas concentration inside insulating glass units without destroying or altering the edge seal. The new standard, ASTM E2649 , Test Method for Determining Argon Concentration in Sealed Insulating Glass Units Using Spark Emission…
-
Two recently approved ASTM International standards provide user-friendly tests for properties of sintered metallurgy products. The new standards, developed by Subcommittee B09.04 on Bearings, are ASTM B962 , Test Methods for Density of Compacted or Sintered Power Metallurgy (PM) Products Using Archimedes’ Principle, and ASTM B963 , Test Methods for Oil Content, Oil-Impregnation Efficiency and…
-
Insulating concrete form systems are gaining acceptance as energy efficient building envelopes for both residential and commercial construction, with more than 80 ICF products available. In order to deal with the varying quality of ICFs, ASTM International Committee E06 on Performance of Buildings has developed a new standard, ASTM E2634 , Specification for Flat Wall Insulating Concrete Form (ICF…
-
ASTM Committee F10 on Livestock, Meat and Poultry Evaluation Systems has approved a new standard, F2717 , Guide for the Development of Independent Third-Party Verification. The standard, which was developed by Subcommittee F10.20 on Device Performance Criteria, provides an internationally recognized set of guidelines for companies that test the accuracy of livestock, meat and poultry evaluation…