Search
Advanced search
Filter by category
Filter by committee
Search results
-
Since the appearance of the first California-type models around 1940, the profilograph has been a popular device used for quality control in the construction of pavements. Both roadway and airfield landing agencies have adopted roughness indexes computed from profilograph-derived measurements as a level of construction quality. Emerging high-speed inertial profilers can now quickly collect…
-
A proposed new standard being developed by ASTM International Committee E17 on Vehicle-Pavement Systems will be the first to describe how truth-in-data should be applied to traffic monitoring data collection, summarization and reporting. WK25280 , Practice for Highway Traffic Monitoring Truth-in-Data, is under the jurisdiction of Subcommittee E17.52 on Traffic Monitoring. Current traffic…
-
Flow characteristics of fine metal powders are important in filling dies for pressing of powder metallurgy compacts, which are later sintered and sometimes machined into finished parts. The flow rate, as measured by a new ASTM standard, determines the flow necessary for a precise quantity of powder to be introduced into the die. The new standard, B964 , Test Methods for Flow Rate of Metal Powders…
-
Being able to compile and interpret data on how traffic turns through an intersection could have an impact on future environmental and safety decisions regarding intersection geometry and traffic control. However, until recently no standard has existed to properly obtain and use this data. Now, ASTM International Committee E17 on Vehicle-Pavement Systems has approved E2667 , Practice for…
-
Two recently approved ASTM International standards provide user-friendly tests for properties of sintered metallurgy products. The new standards, developed by Subcommittee B09.04 on Bearings, are ASTM B962 , Test Methods for Density of Compacted or Sintered Power Metallurgy (PM) Products Using Archimedes’ Principle, and ASTM B963 , Test Methods for Oil Content, Oil-Impregnation Efficiency and…
-
The use of rolling devices can provide a means to evaluate the adhesion of weather seals, for quality control in new installations, general evaluation of existing installations, and the investigation of water and air leakage through building enclosures. In order to better facilitate the use of rolling devices, ASTM International Committee C24 on Building Seals and Sealants is developing a…
-
A request from the United States Navy was the impetus behind the development of a new ASTM International standard, E2630 , Test Method for Luminance Ratio of a Fluorescent Specimen Using a Narrow Band Source. The new standard was developed by Subcommittee E12.05 on Fluorescence, part of ASTM International Committee E12 on Color and Appearance. Richard Harold, consultant, Color and Appearance…
-
First generation gonioapparent colorants are materials pigmented with metal flakes that change lightness as illumination angles change. Used heavily in automotive coatings, the first generation of gonioapparent materials was covered by ASTM International standard E2194 , Practice for Multiangle Color Measurement of Metal Flake Pigmented Materials, first published in 2003. Now, a second generation…
-
ASTM International Committee E12 on Color and Appearance has approved a new standard that describes techniques for planning and analyzing the results of an interlaboratory study conducted for certain test methods within E12. E 2480 , Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method with Multi-Valued Measurands, is under the jurisdiction of Subcommittee…
-
Drawing on the best practices of the U.S. Federal Highway Administration and the states, ASTM International Committee E17 on Vehicle-Pavement Systems has developed a new standard, E 2561 , Practice for Installation of Inductive Loop Detectors. E 2561 is under the jurisdiction of Subcommittee E17.52 on Traffic Monitoring. Inductive loop detectors are installed in sawed slots in roadway pavement…