Search
Advanced search
Filter by category
Filter by committee
Search results
-
ASTM International Committee F12 on Security Systems and Equipment invites all interested parties to participate in the current revision of ASTM F967 , Practice for Security Engineering Symbols. The standard is under the jurisdiction of Subcommittee F12.10 on Systems, Products and Services. According to Ed Conrath, senior principal, Protection Engineering Consultants, and F12 committee chairman,…
-
ASTM Committee G02 on Wear and Erosion is including a field trip in the plans for its Dec. 8-9 meeting in Jacksonville, Fla. Committee members will be visiting the Tribology Laboratory in the mechanical engineering department at the University of Florida in Gainesville. The Tribology Laboratory is actively involved in a wide variety of tribological research and tribology education projects. The…
-
“Bumping” is a process that can allow virtually anyone to covertly operate a pin tumbler lock. A long-held locksmith secret, bumping has become more well known as videos describing the process of making and using a bump key have surfaced on the Internet. Potential intruders can use the bumping process to break into homes and other buildings while leaving the impression that something must have…
-
A new ASTM standard will be useful to slide and engine companies, as well as makers of bushing materials, in studies that involve the measurement of system friction forces. The new standard, ASTM G203 , Guide for Determining Friction Energy Dissipation in Reciprocating Tribosystems, was developed by Subcommittee G02.50 on Friction, part of ASTM International Committee G02 on Wear and Erosion.…
-
Flow characteristics of fine metal powders are important in filling dies for pressing of powder metallurgy compacts, which are later sintered and sometimes machined into finished parts. The flow rate, as measured by a new ASTM standard, determines the flow necessary for a precise quantity of powder to be introduced into the die. The new standard, B964 , Test Methods for Flow Rate of Metal Powders…
-
Two recently approved ASTM International standards provide user-friendly tests for properties of sintered metallurgy products. The new standards, developed by Subcommittee B09.04 on Bearings, are ASTM B962 , Test Methods for Density of Compacted or Sintered Power Metallurgy (PM) Products Using Archimedes’ Principle, and ASTM B963 , Test Methods for Oil Content, Oil-Impregnation Efficiency and…
-
ASTM International Committee F12 on Security Systems and Equipment has approved a new standard, F 2656 , Test Method for Vehicle Crash Testing of Perimeter Barriers. The new test method, developed by Subcommittee F12.10 on Systems, Products and Services, provides a range of vehicle impact conditions, designations and penetration performance levels for the testing of perimeter barriers that are…
-
Subcommittee G02.10 on Erosion by Solids and Liquids, part of ASTM International Committee G02 on Wear and Erosion, is interested in hearing from anyone who uses cavitation erosion testing in their work. The objective of this survey is to help the subcommittee determine the current degree of interest in and importance of cavitation erosion test methods. The subcommittee is especially interested…
-
It has become a common scene: a driver in a parking lot suddenly loses control of a car, sending it into a storefront or other pedestrian area. In an effort to minimize the injury and damage caused by such crashes, ASTM International Committee F12 on Security Systems and Equipment is developing a proposed new standard, WK13074 , Test Method for Crash Testing of Low Speed Pedestrian Barriers. The…
-
A proposed new standard being developed by ASTM International Committee B09 on Metal Powders and Metal Powder Products offers a solution to the challenge of handling and characterizing very fine powders. Subcommittee B09.02 on Base Metal Powders is developing the proposed standard, WK13023 , Test Method for Determination of Tap Density of Metallic Powders by a Constant Volume Measuring Method. …